FUJITSU M8000 - Manual (Page 115)

moveboard(8)
System Administration 93
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
■ You can execute the moveboard(8) command under the environment where the
following services, managed by the Solaris Service Management Facility (SMF),
are in operation:
■
Domain SP Communication Protocol (dscp service) is working properly and
the network with XSCF has been established
■
Domain Configuration Server (dcs service) is working properly
■ Sun cryptographic key management daemon (sckmd service) is working
properly
■ When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
■ If "-c configure" is specified when either of the following conditions apply to
the domains, the XSB is configured in the domain configuration:
■ The Solaris OS of both the source and destination domains are running.
■ The Solaris OS of the destination domain is running even though the source
domain is powered off.
■ If "-c assign" is specified when either of the following conditions apply to the
domains, the XSB is assigned to the domain configuration:
■
The Solaris OS of the source domain is running.
■
The source domain is powered off
■ If "-c reserve" is specified when either the domain power of the move source
has been turned off or the Solaris OS is not running, the XSB is immediately
disconnected from the domain of the move source and assigned to the domain of
the move destination
■ Moving the XSB involves the following internal operations and therefore
command execution may take time.
■
Disconnecting the hardware resource of the XSB from the Solaris OS
■ Running a hardware diagnosis on the XSB when connecting it
xsb Specifies the XSB number to be moved. Multiple xsb operands are
permitted, separated by spaces. The following xsb form is
accepted:
x–y
where:
x An integer from 00–15.
y An integer from 0–3.