FUJITSU M8000 User Manual
Page 305
setupplatform(8)
System Administration
283
EXAMPLE 3
Enabling ssh.
EXAMPLE 4
Configuring the Altitude.
xscf#0-lan#0 default gateway: 192.168.1.1
Are these settings correct? [y|n]:
y
XSCF> setnetwork xscf#0-lan#0 -m 255.255.254.0 192.168.1.4
. . .
XSCF>
setupplatform -p network
Do you want to set up the XSCF network interfaces? [y|n]:
n
Do you want to set up the DSCP network? [y|n]:
n
Do you want to set up the domain name service? [y|n]:
n
Do you want to set up the network time protocol? [y|n]:
n
Do you want to set up ssh? [y|n]:
y
Enable ssh service? [y|n]:
y
XSCF> setssh -q -y -c enable
Do you want to set up https? [y|n]:
n
. . .
XSCF>
setupplatform -p altitude
Do you want to set up the chassis altitude? [y|n]:
y
Chassis altitude is already configured:
Chassis altitude in meters: 200
Continue setting up the chassis altitude? [y|n]:
y
Chassis altitude in meters: 400
Chassis altitude in meters: 400
Is this setting correct? [y|n]:
y
XSCF> setaltitude -s altitude=400
400m
The specified altitude becomes valid when the circuit breakers of the system
are switched on again.
Do you want to reboot the XSCF now? [y|n]:
n
XSCF>