FUJITSU M8000 User Manual
Page 431
shownetwork(8)
System Administration
409
■
In the M8000/M9000 servers and when the takeover IP address has been
disabled by setnetwork(8) command, nothing will be displayed even though
the takeover IP address is specified by the shownetwork(8) command.
■
The setnetwork(8) command configures a network interface used by the XSCF.
EXAMPLES
EXAMPLE 1
Displays the information for XSCF-LAN#0 on XSCF unit 0.
EXAMPLE 2
Displays the information for XSCF-LAN#1 on XSCF unit 0 in the M3000/
M4000/M5000 server.
EXAMPLE 3
Displays the information for ISN on the XSCF unit 0.
XSCF>
shownetwork xscf#0-lan#1
xscf#0-lan#1
Link encap:Ethernet HWaddr 00:00:00:12:34:56
inet addr:192.168.10.11 Bcast: 192.168.10.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:54424 errors:0 dropped:0 overruns:0 frame:0
TX packets:14369 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20241827 (19.3 MiB) TX bytes:2089769 (1.9 MiB)
Base address:0x1000
XSCF>
shownetwork lan#1
xscf#0-lan#1
Link encap:Ethernet HWaddr 00:00:00:12:34:56
inet addr:192.168.10.11 Bcast: 192.168.10.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:54424 errors:0 dropped:0 overruns:0 frame:0
TX packets:14369 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20241827 (19.3 MiB) TX bytes:2089769 (1.9 MiB)
Base address:0x1000
XSCF>
shownetwork xscf#0-if
xscf#0-if
Link encap:Ethernet HWaddr 00:00:00:12:34:56