FUJITSU M8000 - Manual (Page 216)

sethostname(8)
194 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
OPERANDS The following operands are supported:
EXTENDED
DESCRIPTION
■ To reflect the host name and the DNS domain name to XSCF, execute the
applynetwork
(8) command. After reflected the information, use the
rebootxscf (8) command to reset XSCF to complete the setting.
■ The currently set host name and DNS domain name of the XSCF unit can be
checked by using the shownetwork(8) command.
EXAMPLES EXAMPLE 1 Sets the host name scf0-hostname for XSCF unit 0.
EXAMPLE 2 Sets the DNS domain name example.com for XSCF unit.
EXIT STATUS The following exit values are returned:
SEE ALSO applynetwork(8) , rebootxscf(8), showhostname(8)
hostname Specifies a host name to be set for the XSCF unit. The hostname is
specified in up to 64 characters, not in Fully Qualified Domain
Name (FQDN) but in an abbreviated form. If a host name
exceeding 64 characters is specified, an error occurs.
Alphanumeric character and "-" can be used. However, a host
name must always begin with an alphabetic character and end
with an alphanumeric character. If "localhost" specified, an
error occurs.
xscfu Specifies the name of the XSCF unit to be set. The following
values can be specified, depending on the system configuration.
If no value is specified, an error occurs.
xscf#0 XSCF unit 0
xscf#1 XSCF unit 1 (In the M8000/M9000 servers)
XSCF> sethostname xscf#0 scf0-hostname
XSCF> sethostname -d example.com
0 Successful completion.
>0 An error occurred.