ATL Telecom AM200 - Manual (Page 88)

ATL User Guide
AM200 Modem 88
Clock Signal Lost Alarm Enable
The option only applies if the interface mode has been set to DTE. There are two options:
True - The loss of the incoming clock signal will be reported as a trap.
False - The loss of the incoming clock signal is not reported.
Clock Out Of Range Alarm Enable
The option only applies if the interface mode has been set to DTE. There are two options:
True - Reports that the incoming clock signal is out of range.
False - Is not reported.
Circuit106 Clamp On
The option only applies if the interface mode has been set to DTE. There are two options:
True - Clamps the CTS circuit to ON
False - CTS follows RTS
Figure 61 Nx64 User Port screen