ATL Telecom AM200 - Manual (Page 21)

ATL User Guide
AM200 Modem
21
6
6 QUICK START GUIDE
This section of the manual is intended to allow the user to set up the AM200 in a simple point-to-point
configuration quickly, and simply.
Figure 11 Point-to-Point Configurations
Each of these configurations assumes that the AM200s start in the factory default configuration. The AM200
can be returned to its factory default state by using the following CLI command:
--> system config restore factory ↵↵
6.1 SET ONE END TO CO
All configurations require one AM200 to be configured as a CO, and the other as a CPE. AM200 defaults to
a CPE, so the first thing we must do is set one of the units to be a CO. This is done using the following CLI
command:
--> am200 set interface local dslmode co ↵↵
6.2 LINE RATE
By default AM200 will rate adapt to the highest line rate it can achieve on the line it is connected to. The rate
being used can be found by using the following command:
--> am200 show interface local currentlinerate ↵↵
Alternatively the line rate can be specified. The line rate should be set at the CO end only. See section 8.8 of
this manual for instructions on how to set the line rate.
AM200 AM200
CO CPE
Term
Test Us
er
L ine
atl AM200
Term
Te
st User Line
atl AM200
1 Copper pair
G703/X.21/V.35/RS530/
100BaseT