ATL Telecom AM200 - Manual (Page 40)

ATL User Guide
AM200 Modem 40
Type in :-
--> am200 set interface local linerate ??
The CLI will respond with :-
- 192K, 256K, 320K, 384K, 448K, 512K,
- 576K, 640K, 704K, 768K, 832K, 896K,
- 960K, 1024K, 1088K, 1152K, 1216K, 1280K,
- 1344K, 1408K, 1472K, 1536K, 1600K, 1664K,
- 1728K, 1792K, 1856K, 1920K, 1984K, 2048K,
- 2112K, 2176K, 2240K, 2304K, RateAdaption
--> am200 set interface local linerate
To set the line rate to 2048k, type in :-
--> am200 set interface local linerate 2048K ↵↵
The line rate has now been set to 2048k.
To check that the line rate type in :-
--> am200 show interface local linerate ↵↵
The CLI will respond with:
Line Rate: 2048K
-->
8.5 CLI AUTO COMPLETE
You can use the tab key to auto-complete an entry. The CLI will compare your current partial entry against
the list of possible complete entries, and find a match. If your partial entry matches more than one complete
entry, you will have to carry on typing until your partial entry is unique.
The following example illustrates the auto-complete feature.
-->am (press Tab key)
As long as the partial entry is enough to uniquely identify a complete entry, then pressing tab will successfully
auto-complete the entry. The CLI will respond with:
-->am200
If the partial entry is not enough to uniquely identify a complete entry, then pressing tab will auto-complete
the entry up to a point, whereby you must continue typing in order for the partial entry to uniquely identify
a complete entry.