ATL Telecom AM200 - Manual (Page 111)

ATL User Guide
AM200 Modem
111
10
10.7.2.2 NTimes64K
This allows the user to set the amount of DSL bandwidth used by the interface. In an end to end connection
the Ntimes64 setting on the CO and the CPE units must be the same. To disable the Nx64 port the NTimes64K
must be set to zero.
10.7.2.3 TYPE
This allows you to specify the operation of the interface. Three options are available, V11, V35 or RS530.
10.7.2.4 MODE
This allows you to set the timing characteristic of the Nx64 interface. There are two options
DCE - This is the option normally specified on the CPE unit.
DTE - This option receives an external timing signal and is normally specified on the CO unit.
Local:Mode=
DceTerminated
RETURN
DteTerminated
Local:Type=
V11
RETURN
V35
RS530
Local:Nx64k=
0 (off)
RETURN
64k
:
2304k
LineRate