ATL Telecom AM200 - Manual (Page 23)

ATL User Guide
AM200 Modem
23
6
To change the IP address use the following CLI command:
--> ip set interface iplan ipaddress ↵↵
Where is the desired IP address, and is the desired subnet mask.
6.3.2 CHANGING AN AM200 FROM ROUTER TO BRIDGE
Probably the quickest way to change an AM200 to be a Bridge is to restore the factory default settings as
described at the start of the section. Otherwise the following commands will configure the AM200 to be a
bridge.
First remove the router configuration. Type in:-
--> ip clear interfaces ↵↵
--> ip clear routes ↵↵
--> ip clear riproutes ↵↵
Then add interfaces for each side of the bridge, e.g. "lan" for the Ethernet user port and "wan" for the DSL
connection: Type in:-
--> bridge add interface lan ↵↵
--> bridge add interface wan ↵↵
Then attach the interfaces to the appropriate transports. Type in:
--> bridge attach lan ethernet ↵↵
--> bridge attach wan hdlc ↵↵
Finally to allow IP management of the unit, create an IP interface "iplan" and attach the bridge to the IP stack:
--> ip add interface iplan ↵↵
--> ip attachbridge iplan ↵↵