ATL Telecom AM200 - Manual (Page 53)

ATL User Guide
AM200 Modem
53
8
8.17 EXAMPLE CONFIGURATION
In the following examples two AM200s will be configured using the CLI. The configurations will then be
saved. One unit will be configured as a CO (unit 1) the other as a CPE (unit 2) using the same interface. Using
these configurations both units could be connected back to back Ref example shown in Figure 2.
8.17.1 G703 Example configuration
To set up a G703 link starting from the factory default settings.
Unit 1
Mode CO
Line Rate 2048kbps
User Port G703
Framming E1
Timeslots All 32 activated
Timing Local
Unit 2
Mode CPE
Line Rate RateAdaption
User Port G703
Framming E1
Timeslots All 32 activated
Timing Local
Unit 1
Type in :-
--> am200 set interface local dslmode co ↵↵
--> am200 set interface local linerate 2048K ↵↵
--> hdlc set interface local adminstatus down ↵↵
--> hdlc set interface local ntimes64k 0 ↵↵
--> ds1 config set interface local adminstatus up ↵↵
--> ds1 config set interface local channelization disabled ↵↵
--> system config save normal ↵↵