ATL Telecom AM200 - Manual (Page 52)

ATL User Guide
AM200 Modem 52
IP RIP routes
Destination | Mask | Gateway | Cost | Time | Source
---------------------|--------------------|--------------------|--------|--------|----------
10.11.0.0 | 255.255.0.0 | 192.168.1.2 | 2 | 180s | wan
-------------------------------------------------------------------------------------------
8.14 RESTORING FACTORY DEFAULT
The AM200 can be defaulted back to the original Factory default setting by typing:-
--> system config restore factory ↵↵
Wait for the CLI confirmation message before you switch off
Note: This will cause the IP address to be reset to the default setting.
8.15 SAVING CLI CHANGES
After doing any changes you must save the changes. The settings can be saved either in the ‘normal’ or
backup’ file. To save the settings into the ‘normal’ file, enter the following command and press the return key.
Type in:
--> system config save normal ↵↵
Note: Wait for the CLI confirmation message before you switch off the AM200.
If you do not enter this command then any changes will be lost if the AM200 is switched off.
8.16 RESTORING TO SAVED SETTINGS
The AM200 can be set back to either of the two saved settings Use the following CLI command to set the
AM200 to the settings saved in the ‘normal’ file.
--> system config restore normal ↵↵
Use the following CLI command to set the AM200 to the settings saved in the ‘backup’ file.
--> system config restore backup ↵↵