5 nx64, Nx64 – ATL Telecom AM200 User Manual

Page 27

ATL User Guide

AM200 Modem

6.5

NX64

To set up an Nx64 link. Start from factory default configuration. Set one unit to be a CO as described above.

Then on both units (CO and CPE) input the following commands.

First disable the Ethernet port, which is enabled by default. Type in:

--> hdlc set interface local adminstatus down

↵↵

--> hdlc set interface local ntimes64k 0

↵↵

Then enable the Nx64 port. Type in

--> nx64 set interface local adminstatus up

↵↵

--> nx64 set interface local ntimes64k linerate

↵↵

This will enable nx64 port in the following configuration

V35 DCE interface

Data rate equal to current line rate

Customer

Terminal

Customer

Terminal

X.21/V.35/RS530

copper pair

DCE

AM200

CPE