ATL Telecom AM200 - Manual (Page 46)

ATL User Guide
AM200 Modem 46
--> nx64 set interface local type
e.g. To set the user port to V35 type in:
--> nx64 set interface local type v35
8.10.3.3 Setting The Nx64k User Port Data Rate
Setting the data rate to a value greater than 0 enables the Nx64 User port. To view the current Nx64k Data
Rate for the AM200 unit type:
--> nx64 show interface local ntimes64k ↵↵
The CLI will respond with:
NTimes64K: 0
-->
The data rate is set using the set command. In the following example the Data Rate is set to 2048K.
Type in:
--> nx64 set interface local ntimes64k 2048K ↵↵ (to set the User Rate to 2048K)
To disable the Nx64 User port set the data rate to 0 as in the following example.
Type in:
--> nx64 set interface local ntimes64k 0 ↵↵ (to disable the Nx64 User port)
Note
To view all of the possible line rate setting use the ? command type :-
--> nx64 set interface local ntimes64k ? ↵↵
The CLI will respond with:
- 0 (Off)
- 64K, 128K, 192K, 256K,
- 320K, 384K, 448K, 512K,
- 576K, 640K, 704K, 768K,
- 832K, 896K, 960K, 1024K,
- 1088K, 1152K, 1216K, 1280K,
- 1344K, 1408K, 1472K, 1536K,
- 1600K, 1664K, 1728K, 1792K,