ATL Telecom AM200 - Manual (Page 42)

ATL User Guide
AM200 Modem 42
The line rate is set using the set linerate command. In the following example the Line Rate is set to 2048K.
Type in:
--> am200 set interface local linerate 2048K ↵↵ (to set the User Rate to 2048K)
Note
To view all of the possible line rate setting use the ? command as in the example below.
Type in :-
--> am200 set interface local linerate ↵↵
The CLI will respond with :-
- 192K, 256K, 320K, 384K, 448K, 512K,
- 576K, 640K, 704K, 768K, 832K, 896K,
- 960K, 1024K, 1088K, 1152K, 1216K, 1280K,
- 1344K, 1408K, 1472K, 1536K, 1600K, 1664K,
- 1728K, 1792K, 1856K, 1920K, 1984K, 2048K,
- 2112K, 2176K, 2240K, 2304K, RateAdaption
--> am200 set interface local linerate
It is recommended that the DSL Line rate of the CPE unit is set to RateAdaption (it’s factory default setting).