ATL Telecom AM200 - Manual (Page 135)

ATL User Guide
AM200 Modem
135
15
15 COMPLIANCE NOTES
The TTE network statements and the declaration of conformity statement to EC directive 1999/5/EC are
provided inside the front cover of the AM200 User Guide together with safety information.
15.1 TELECOMMUNICATION STANDARDS
The equipment is in conformity with the following International/National Standards.
ITU-TK20 Resistibility of Telecommunication Switching Equipment To Over Voltage and
Over Current.
ITU-TK21 Resistibility of Subscriber's Terminal Equipment To Over Voltage and Over
Current.
ETSI EN300386 V1.2.1 EMC Requirements for Telecommunication Network Equipment
EN60950-1: 2002 Information Technology Equipment - Safety
G.703 Physical/Electrical Characteristics of Hierarchical Digital Interfaces.
G.704 Synchronous Frame Structures Used At 1544, 6312, 2048, 8448 and 44737
Kbits/s Hierarchical Levels.
G.706 Frame Alignment And Cyclic Redundancy Check (Crc) Procedures Relating To
Basic Frame Structures Defined In Recommendation G.704.
G.821 Error performance of an international digital connection operating at a bit rate
below the primary rate and forming part of an integrated services digital
network.
G.823 The control of jitter and wander within digital networks, based on the 2048
kbit/s hierarchy.
G.991.2 Single-Pair Highspeed Digital Subscriber Line (SHDSL) Transceivers.
G.994.1 Handshake Procedures for Digital Subscriber Line (DSL) Transceivers.
V.11 Electrical characteristics for balanced double-current interchange circuits
operating at data signalling rates up to 10 Mbit/s.
V.35 Data transmission at 48 kbit/s using 60-108 kHz group band circuits
X.24 List of definitions for interchange circuits between Data Terminal Equipment
(DTE) and Data Circuit-terminating Equipment (DCE) on public data networks