Adding a service provider, Deleting a service provider, Pbx setup – IPitomy IP1000 User Guide User Manual
Page 99: General, Edit general settings

Adding a Service Provider
1. Select a service provider from the drop-down box to the left of the
Trunks list.
2. Click
Add. The service provider will appear in the list.
3. Click on the Name of the provider.
4. Click
the
Up or Down button to position the service provider in the list in
the order calls are to be routed over this resource.
Deleting a Service Provider
1. Click on a Service Provider in the list.
2. Click
Delete.
3. Click
on
Save Changes.
4. Click
on
Apply Changes when ready to implement these changes to the
system.
Implementation Note 5
Default Settings For Existing Routes
The Outgoing Call Routes already in the IPitomy 1000 have the following default
settings Route Type and route Number. These default settings cannot be changed.
The Name of the route, service provider associated with the route and the order in
which service providers are selected for the route can be changed.
PBX Setup
PBX setup is used by a System Administrator to manage system-specific and system-wide
capabilities of the IPitomy1000.
General
General setup manages the Administrative Settings for the system: User Name,
Password and Time Zone.
Edit General Settings
1. Click
on
PBX Setup and General. The General System Setup page will
appear.
2. Enter
an
Administrative User Name.
3. Enter
an
Administrative Password.
4. Re-enter
the
Password.
5. Select
a
Time Zone from the drop-down box provided.
6. Select
a
System Operator Destination. This is the destination that
people will go to when pressing ‘0’ while in a voicemail box, if Allow
Operator is enabled on a voicemail box.
Copyright
© IPitomy Communication, LLC
94
0007VRF