6 – shared storage software setup, Install the fibre channel driver on windows nt – HP LXR 8000 User Manual
Page 91
35
6 – Shared Storage Software Setup
Install the Fibre Channel Driver on Windows NT
The Hewlett-Packard Model 30/FC Disk Array and the cabinet should be powered down at this time.
To install the Fibre Channel driver Windows NT, perform the following steps on each HP NetServer in the cluster:
a.
Power up the HP NetServer if it is not already powered up.
b.
Start Windows NT if it is not running and log into an account with administrative privileges.
c.
Insert the Hewlett-Packard driver diskette into the floppy drive.
d.
From the
Start
bar, select
Settings
.
e.
From the
Settings
menu, click
Control Panel
.
f.
From the
Control Panel
window, double-click
SCSI Adapters
.
g.
From the
SCSI Adapters
window, click the
Drivers tab
.
h.
From the
Drivers
window, click
Add
.
i.
Click
Have Disk
.
j.
From the floppy disk drive, click
HP HHBA-5000X Fibre Channel Host Controller
.
k.
Click
OK
.
When the installation is complete, remove the diskette, shut down Windows NT, and, without powering up the disk
array, reboot the HP NetServer to load the driver.
Power down the HP NetServer.