Monitoring sessions, Troubleshooting, Before you begin – HP A.06.11 User Manual
Page 204: 204 troubleshooting
2.
Run:
run {
allocate channnel 'dev0' type disk;
replicate controlfile from 'TMP_FILENAME';
release channel 'dev0';
}
where TMP_FILENAME is the folder to which the control file was restored.
Monitoring sessions
You can monitor currently running sessions in the Data Protector GUI. When you run
an interactive backup or a restore session, a monitor window shows you the progress
of the session. Closing the GUI does not affect the session.
You can also monitor sessions from any Data Protector client with the User
Interface
component installed, using the Monitor context.
On how to monitor a session, see the online Help index: “viewing currently running
sessions”.
System messages generated during backups are sent to both the SAP R/3 and the
Data Protector monitor. However, mount requests are sent only to the Data Protector
monitor.
Troubleshooting
This section lists general checks and verifications plus problems you might encounter
when using the Data Protector SAP R/3 integration.
For general Data Protector troubleshooting information, see the HP Data Protector
troubleshooting guide.
Before you begin
•
Ensure that the latest official Data Protector patches are installed. See the online
Help index: “patches” on how to verify this.
•
See the HP Data Protector product announcements, software notes, and references
for general Data Protector limitations, as well as recognized issues and
workarounds.
•
For an up-to-date list of supported versions, platforms, and other information, see
the latest support matrices at
.
Integrating SAP R/3 and Data Protector
204