HP KAYAK XM600 - Manual (Page 28)

2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing or Installing a Processor
28
Configuring the Operating System for use with Dual Processors
Configuring Windows 2000
To obtain the full benefits of a dual processor configuration you will need to
configure Windows 2000 as follows:
1 Click on Start, Settings then Control Panel.
2 In the Control Panel window, double-click on Administrative Tools.
3 In the Administrative Tools window, double-click on Computer
Management.
4 In the left section of the Computer Management window under the
System Tools section, click on
Device Manager.
5 In the right section of the Device Manager window, double-click on
Computer then double click on ACPI Uniprocessor PC.
6 In the Properties window that appears, click on the Driver tab and click
on the Update Driver button.
7 Click on Next to begin the Upgrade Device Driver Wizard. In the next window,
select Display a list of known drivers then click on Next to continue.
8 In the next window, select Show all hardware of this device class and in the
Manufacturers section, select [Standard computers] and in the Models section,
select
ACPI Multiprocessor PC then click on the Next button.
9 Click on Next to install the driver and when this is complete, click on
Finish. Close all open windows and restart your PC when prompted.
After restarting, Windows 2000 will make full use of your new dual
processor configuration.
Configuring Windows NT 4.0 using HP DualExpress!
Included with the HP Processor Accessory is the HP DualExpress!
application. This application is to be used when upgrading Windows NT 4
from a single-processor to a multi-processor system.
NOTE Do not use the HP DualExpress! application when upgrading Windows
2000 from a single-processor to a multi-processor system.
Using an installation Wizard, HP DualExpress! guides you through the
operating system upgrade and will take approximately five minutes.
Launching HP
DualExpress! The second processor must be installed and the PC booted. For now,
Windows NT will still only recognize the original processor. Insert the HP
DualExpress! floppy disk in the floppy disk drive and follow the
instructions. When the upgrade is complete, the system reboots. This time
a multi-processing system is recognized.