HP 3200 - Manual (Page 90)

10 Use the scan features
This chapter contains information on scanning to an application on your computer, to
an HP Instant Share destination, and to a memory card or storage device. It also
contains information on scanning slides and negative film using the control panel.
Scanning is the process of converting text and pictures into an electronic format for
your computer. You can scan almost anything (photos, magazine articles and text
documents), as long as you are careful not to scratch the glass on your HP All-in-One.
Scanning to a memory card or storage device makes your scanned images even
more portable.
Note On a Mac, you can change the HP Scan Pro default scan settings. For
more information, see the onscreen HP Image Zone Help .
Scan an image
For information about how to scan from the computer, and how to adjust, resize,
rotate, crop, and sharpen your scans, see the onscreen
HP Image Zone Help that
came with your software.
To use the scan features, your HP All-in-One and computer must be connected and
turned on. The HP All-in-One software must also be installed and running on your
computer prior to scanning. To verify that the HP All-in-One software is running on a
Windows PC, look for the HP All-in-One icon in the system tray at the lower right side
of the screen, near the time. On a Mac, the HP All-in-One software is always running.
Note Closing the HP Digital Imaging Monitor icon in your Windows system
tray can cause your HP All-in-One to lose some of its scan functionality and
result in the
No Connection error message. If this happens, you can restore
full functionality by restarting your computer or by starting the HP Image Zone
software.
Scan an original to a computer
You can scan originals placed on the glass directly from the control panel.
1.
Load your original print side down in the right front corner of the glass.
2. Press Scan , if it is not already lit.
– If your HP All-in-One is directly connected to a computer with a USB cable,
the
Scan To menu appears on the color graphics display. Skip to step 4.
– If your HP All-in-One is network-connected, the Scan Menu appears on the
color graphics display. Continue to the next step.
3. If your HP All-in-One is connected to one or more computers on a network, do the
following:
–
Press 1 to highlight Select Computer , and then press OK .
The Select Computer menu appears, listing computers connected to the
HP All-in-One.
User Guide 87
Scan