HP 3200 - Manual (Page 46)

Parameter Description
www.hp.com contains the domain name hp.com. The DNS on the
Internet translates the domain name into an IP address. Devices
use the IP addresses to refer to one another.
●
IP Address: The IP address of the domain name server.
● Not Specified: The IP address is not specified, or the device
is initializing.
Note Check to see if a DNS IP address appears on the network
configuration page. If no address is shown, obtain the DNS IP
address from your Internet service provider (ISP).
Link
Configuration The speed at which data is transmitted over a network:
●
10TX-Full: For wired network.
● 10TX-Half: For wired network.
● 100TX-Full: For wired network.
● 100TX-Half: For wired network.
● None: Networking is disabled.
Total Packets
transmitted The number of packets transmitted by the HP All-in-One without
error since it has been turned on. The counter clears after the
HP All-in-One is turned off. When a message is transmitted over a
packet-switching network, it is broken up into packets. Each
packet contains the destination address as well as the data.
Total Packets
received The number of packets received by the HP All-in-One without
error since it has been turned on. The counter clears after the
HP All-in-One is turned off.
Bluetooth settings
The following table describes the Bluetooth settings shown on the network
configuration page.
Parameter Description
Device Address The hardware address of the Bluetooth device.
Device Name The device name assigned to the printer, which can identify it on a
Bluetooth device.
Passkey A value that the user must enter in order to print via Bluetooth.
Visibility Shows whether or not the HP All-in-One is visible to Bluetooth
devices that are within range.
●
Visible to all: Any Bluetooth device within range can print to
the HP All-in-One.
● Not visible: Only Bluetooth devices that have stored the
device address of the HP All-in-One can print to it.
(continued)
User Guide 43
Network setup