HP 3200 - Manual (Page 41)

View and print network settings
You can display a summary of the network settings on the HP All-in-One control
panel, or you can print a more detailed configuration page. The network configuration
page lists all of the important network settings such as the IP address, link speed,
DNS, and mDNS. For information on the network settings, see
Network configuration
page definitions .
1. Press Setup .
2. Press until Network is highlighted, then press OK .
The Network Menu appears.
3. Do one of the following:
–
To display wired network settings, press 1 , then press 2 .
This selects Display Summary and then displays a summary of the wired
(Ethernet) network settings.
– To print the network configuration page, press 1 , then press 1 again.
This selects View Network Settings and then prints the network
configuration page.
Restore network defaults
You can reset the network settings to what they were when you purchased your
HP All-in-One.
1.
Press Setup .
2. Press until Network is highlighted, then press OK .
The Network Menu appears.
3. Press 2 , and then press 1 or OK to confirm.
This selects Restore Network Defaults .
Change advanced network settings from the control panel settings
The advanced network settings are provided for your convenience. However, unless
you are an advanced user, you should not change any of these settings. The
advanced settings include
Link Speed and IP Settings .
Set link speed
You can change the speed at which data is transmitted over the network. The default
is
Automatic .
1. Press Setup .
2. Press until Network is highlighted, then press OK .
The Network Menu appears.
3. Press 3 , then press 1 .
This selects Advanced Setup and then displays the Link Speed screen.
4. Press the number next to the link speed that matches your network hardware:
–
1. Automatic
– 2. 10-Full
– 3. 10-Half
Chapter 4
38 HP Photosmart 3200 All-in-One series
Netw
ork
setup