HP 3100 - Manual (Page 41)

To set the dial type
▲ Control panel: Press Setup, press Basic Fax Setup, and then use the Tone or
Pulse Dialing option.
Set the redial options
If the HP Fax was unable to send a fax because the receiving fax machine did not answer
or was busy, the HP Fax attempts to redial based on the settings for the busy-redial and
no-answer-redial options. Use the following procedure to turn the options on or off.
• Busy redial: If this option is turned on, the HP Fax redials automatically if it receives
a busy signal. The factory-set default for this option is ON.
• No answer redial: If this option is turned on, the HP Fax redials automatically if the
receiving fax machine does not answer. The factory-set default for this option is
OFF.
To set the redial options
▲ Control panel: Press Setup, press Advanced Fax Setup, and then use the Busy
Redial or No Answer Redial options.
Set the fax speed
You can set the fax speed used to communicate between your HP Fax and other fax
machines when sending and receiving faxes. The default fax speed is Fast.
If you use one of the following, setting the fax speed to a slower speed might be required:
• An Internet phone service
• A PBX system
• Fax over Internet Protocol (FoIP)
• An integrated services digital network (ISDN) service
If you experience problems sending and receiving faxes, you might want to try setting the
Fax Speed setting to Medium or Slow. The following table provides the available fax
speed settings.
Fax speed setting Fax speed
Fast v.34 (33600 baud)
Medium v.17 (14400 baud)
Slow v.29 (9600 baud)
To set the fax speed from the control panel
1. Press Setup.
2. Select Advanced Fax Setup, and then press Fax Speed.
3. Select an option using the arrow keys, and then press OK.
Change fax settings 37