HP 3500YL - Manual (Page 83)

PIM-DM (Dense Mode)
Configuring PIM-DM
ProCurve(config)# show run
...
ip routing
...
vlan 29
name "VLAN29"
untagged A11-A15,A17
ip address 10.29.30.1 255.255.255.0
ip igmp
exit
vlan 25
name "VLAN25"
untagged A20-A24
ip address 10.38.10.1 255.255.255.0
ip address 10.38.11.1 255.255.255.0
ip address 10.38.12.1 255.255.255.0
ip igmp
exit
vlan 27
name "VLAN27"
untagged A6-A10,A18
ip address 10.27.30.1 255.255.255.0
ip igmp
exit
ip multicast-routing
router rip
exit
router pim
state-refresh 45
trap hardware-mrt-full
exit
vlan 25
ip rip 10.38.10.1
ip rip 10.38.11.1
ip pim-dense
ip-addr 10.38.10.1
exit
vlan 27
ip rip 10.27.30.1
ip pim-dense
ip-addr any
exit
vlan 29
ip rip 10.29.30.1
ip pim-dense
ip-addr any
Note: Dashed lines indicate configuration
settings affecting multicast routing.
Multinetting and IGMP enabled in VLAN 25.
Multicast Routing Configuration for Global Level..
Enables IP routing; required for multicast routing.
Indicates the source-IP-address for multicast
packets forwarded on this VLAN.
Multicast Routing Configuration for VLAN 25.
Multicast Routing Configurations for VLANs 27 and 29.
Figure 3-6. The Multicast Routing Configuration on Switch #1 in Figure 3-4 (Page 3-20)
3-21