HP 3500YL - Manual (Page 275)

IP Routing Features
Configuring OSPF
Syntax: show ip ospf external-link-state
The OSPF external link state display shows the following information:
Table 5-11. CLI Display of OSPF External Link State Information
Field
Link State ID
Router ID
Age
Sequence #
Chksum(Hex)
Content
LSA ID for this LSA. Normally, the destination of the external route,
but may have some “host” bits set.
Router ID of the router that originated this external LSA.
Current age (in seconds) of this LSA.
Sequence number of the current instance of this LSA.
LSA checksum value.
Syntax show ip ospf external-link-state [status] [ subset-options ]
:
router-id < ip-addr >
Subset option to filter displayed external-link-state data to
show LSAs with the specified router ID only. Can also be
filtered by using the
link-state-id or sequence-number
options.
sequence-number < integer >
Subset option to filter displayed external-link-state data to
show LSAs with the specified sequence number. Can also
be filtered by using the
link-state-id or router-id options.
link-state-id < ip-addr >
Subset option to filter displayed external-link-state data to
show LSAs with the specified ID only. Can also be filtered
by using the
sequence-number or router-id options.
Syntax: show ip ospf external-link-state [status ] advertise
Displays the hexadecimal data in the specified LSA packet, the
actual contents of the LSAs. Can also be filtered by using the
link-state-id, router-id, or sequence-number options.
5-101