HP 3500YL - Manual (Page 271)

IP Routing Features
Configuring OSPF
ProCurve(config) show ip ospf interface vlan 4
OSPF configuration and statistics for VLAN 4
OSPF Interface Status for 10.10.10.1
IP Address: : 10.10.10.1 Status : enabled
AreaID : 0.0.0.2 Passive : Yes
State : DOWN Auth-type : none
Cost : 1 Chain :
Type : BCAST Priority : 1
Transit Delay : 1 Retrans Interval : 5
Hello Interval : 10 Rtr Dead Interval : 40
Designated Router: Events : 0
Backup Desig. Rtr: Passive : yes
Figure 5-36. show ip ospf interface Command for a specific VLAN with Passive Configured on an Interface
Displaying OSPF Information
You can use CLI commands to display the following OSPF information:
OSPF Information Type Page
General Information 5-98
Area information 5-99
External link state information 5-100
Interface information 5-102
VLAN and subnet packet statistics 5-105
Link state information 5-108
Neighbor information 5-111
Route information 5-119
Virtual Neighbor information 5-114
Virtual Link information 5-115
OSPF SPF statistics 5-117
OSPF Traps enabled 5-121
5-97