HP 3500YL - Manual (Page 209)

IP Routing Features
Configuring RIP
N o t e Do not enable redistribution until you have configured the redistribution
filters. Otherwise, the network might get overloaded with routes that you did
not intend to redistribute.
Example: To configure the switch to filter out redistribution of static,
connected, or OSPF routes on network 10.0.0.0, enter the following
commands:
ProCurve(config)# router rip
ProCurve(rip)# restrict 10.0.0.0 255.0.0.0
ProCurve(rip)# write memory
N o t e The default configuration permits redistribution for all default connected
routes only.
Syntax: restrict < ip-addr > < ip-mask > | < ip-addr /< prefix length >
This command prevents any routes with a destination address that is included
in the range specified by the address/mask pair from being redistributed by
RIP.
Modify Default Metric for Redistribution
The default metric is a global parameter that specifies the cost applied to all
RIP routes by default. The default value is 1. You can assign a cost from 1 – 15.
Example: To assign a default metric of 4 to all routes imported into RIP, enter
the following commands:
ProCurve(config)# router rip
ProCurve(rip)# default-metric 4
Syntax: default-metric < value >
The < value > can be from 1 – 15. The default is 1.
Enable RIP Route Redistribution
N o t e Do not enable redistribution until you have configured the redistribution
filters. Otherwise, the network might get overloaded with routes that you did
not intend to redistribute.
5-35