HP 3500YL - Manual (Page 352)

Virtual Router Redundancy Protocol (VRRP)
Configuring VRRP
Reconfiguring the Priority for a Backup. When you configure a Backup
in a VR, it is given a default priority of 100. This command is intended for use
where it is necessary to establish a precedence among the Backup routers on
the same network or subnet in a given VR.
Syntax: priority < 1 - 254 >
Used in a VR context of a VLAN where the router is configured
as a Backup. This command changes the Backup’s priority
and is used to establish the precedence of a Backup where there
are multiple Backups belonging to the same network or subnet.
Also, the VR instance must be disabled (the default VR state)
when using this command.
Note: An Owner is automatically assigned the highest prior­
ity, 255, which cannot be changed unless the Owner status is
reconfigured to Backup.
(Range: 1 - 254, where 1 is the lowest precedence; Default: 100)
6-22