HP 3500YL - Manual (Page 278)

IP Routing Features
Configuring OSPF
Displaying OSPF Interface Information for a Specific VLAN
or IP Address
To display OSPF interface information for a specific VLAN or IP address, enter
show ip ospf interface < ip-addr > at any CLI level. For example:
ProCurve(ospf)# sho ip ospf int 10.10.50.1
OSPF Interface Status for 10.3.1836
IP Address : 10.3.18.36 Status : enabled
Area ID : 10.3.16.0
State : BDR Auth-type : none
Cost : 1 Chain :
Type : BCAST Priority : 1
Transit Delay : 1 Retrans Interval : 5
Hello Interval : 10 Rtr Dead Interval : 40
Designated Router : 10.3.18.34 Events : 3
Backup Desig. Rtr : 10.3.18.36
Figure 5-42. Example of Show IP OSPF Interface < ip-addr > Output
Syntax: show ip ospf interface [vlan < vlan-id > | < ip-addr >]
The OSPF interface display for a specific VLAN or IP address has the same
information as the non-specific
show ip ospf interface command for the IP
Address, Area ID, Status, State, Auth-type, Cost, and Priority fields. See the
information for the general command in table 5-12 on page 5-102 for defini­
tions of these fields.
The show ip ospf interface command for a specific VLAN or IP address shows
the following additional information:
5-104