HP 3500YL - Manual (Page 279)

IP Routing Features
Configuring OSPF
Table 5-13. CLI Display of OSPF Interface Information – VLAN or IP Address
Field
Type
Transit Delay
Retrans Interval
Hello Interval
Rtr Dead Interval
Designated
Router
Backup Desig. Rtr
Events
Content
Will always be BCAST for interfaces on this routing switch.
Point-to-point or NBMA (frame relay or ATM) type interfaces
are not supported on the switches covered in this guide.
Configured transit delay for this interface.
Configured retransmit interval for this interface.
Configured hello interval for this interface.
Configured router dead interval for this interface.
IP address of the router that has been elected designated
router on this interface.
IP address of the router that has been elected backup desig­
nated router on this interface.
Number of times the interface state has changed.
If you use show ip ospf interface vlan < vlan-id >, the output will be the same as
shown in the previous table, but for the IP address on the indicated VLAN.
Displaying OSPF Packet Statistics for a Subnet or VLAN
To display the statistics on OSPF packets sent and received on the interfaces
in VLANs and/or subnets on an OSPF-enabled routing switch, including the
number of errors that occurred during packet transmission, enter the
show ip ospf statistics [ vlan < vlan-id > | ip-addr > ] command at any CLI level.
Syntax: show ip ospf statistics [ vlan < vlan-id > | < ip-address > ]
The show ip ospf statistics command displays the following information for
OSPF-enabled VLANs and/or subnets.
■ The VLAN ID displays OSPF packet statistics for all subnets configured
on the VLAN.
■ The IP address displays OSPF packet statistics only for a specified VLAN
subnet.
Syntax: clear ip ospf statistics
5-105