HP 3500YL - Manual (Page 133)

PIM-SM (Sparse Mode)
Configuring PIM-SM on the Router
Enabling or Disabling PIM-SM Per-VLAN
Syntax: ip pim-sparse [ip-addr < any | < ip-addr >>]
vlan < vid >] ip pim-sparse [ip-addr < any | < ip-addr >>]
no [vlan < vid >] ip pim-sparse
This command enables or disables PIM-SM in the designated
VLAN interface and sets the source (and designated router)
IP address for PIM-SM packets sent from the interface.
Executing the command without specifying an IP address
option causes the router to default to the
any option. The no
form of the command disables PIM-SM on the specified VLAN.
To change a currently configured (non-default) source IP
address setting, use the
ip-addr < ip-addr > option, below.
(Default: PIM-SM disabled)
ip-addr any: Enables the router to dynamically determine from
the VLAN’s current IP configuration the source IP address to
use for PIM-SM packets sent from the VLAN interface.
Note: Using this command after a source IP address has
already been set does not change that setting.
— Continued on the next page.—
ip-addr < ip-addr >: Specifies one of the VLAN’s currently
existing IP addresses for use as the source IP address for PIM­
SM packets sent from the VLAN interface. Note that
< ip-addr >
must first be statically configured on the VLAN.
Note: To change an existing source IP address setting, you
must use this command option.
4-29