HP PROLIANT ML330 G6 - Manual (Page 73)

Hardware options installation 73
IMPORTANT: When removing a processor board to install a TPM, the processor, heatsink, and
DIMMs can remain installed on the processor board.
5. Remove the processor board, if necessary (" Remove the processor board " on page 24 ).
6. Locate the TPM connector (" System board components " on page 11 ).
CAUTION: Any attempt to remove an installed TPM from the system board breaks or disfigures
the TPM security rivet. Upon locating a broken or disfigured rivet on an installed TPM,
administrators should consider the system compromised and take appropriate measures to
ensure the integrity of the system data.
7. Install the TPM board. Press down on the connector to seat the board (" System board components "
on page 11 ).
8. Install the TPM security rivet by pressing the rivet firmly into the system board.
9. Install the processor board, if removed (" Install the processor board " on page 25 ).
10. Install the air baffle.
11. Install the access panel (on page 22 ).
12. Do one of the following: