HP PROLIANT ML330 G6 - Manual (Page 59)

Hardware options installation 59
10. Remove the applicable bezel blank from the bezel (" Remove a bezel blank " on page 24 ).
11. Install the access panel (on page 22 ).
12. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
13. Power up the server (on page 20 ).
USB tape drive option
For clarity, the following illustrations include option cabling only.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To install the component:
1. Power down the server (on page 20 ).
2. Do one of the following:
o Open or remove the tower bezel, as needed (" Open or remove the tower bezel " on page 20 ).
o Extend the server from the rack (on page 21 ).
3. Remove the access panel (on page 21 ).
4. Remove the applicable media bay blank (" Remove the media bay blank " on page 23 ).
5. Identify the guide screws (" Identifying guide screws " on page 57 ).
6. Install the guide screws.