HP PROLIANT ML330 G6 - Manual (Page 56)

Hardware options installation 56
Be sure to thread the cables through the rear of the non-hot-plug expansion cage into the server.
9. Connect the cables to the SATA connectors 1-4 on the system board (" System board components " on
page 11 ).
10. Install the air baffle.
11. Install the access panel (on page 22 ).
12. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
13. Power up the server (on page 20 ).
Removable media devices
This section provides the following information and procedures:
• Identifying guide screws (on page 57 )
• SATA optical drive option (on page 57 )
• USB tape drive option (on page 59 )
• Full-height tape drive option (on page 60 )