Epson Action Laser - Manual (Page 65)

The SelecType Control Panel
Use of these buttons is described in more detail in the following
sections.
CONTINUE/RESET
This button has several uses related to
SelecType.
Implementing SelecType changes - After
you exit SelecType (with the printer off
line), hold down
this
button for three
seconds (until the message
RESET
appears) to make your SelecType settings
take effect.
Initializing SelecType settings to factory
defaults - In SelecType mode, hold down
the
CONTINUE/RESET
button for three
seconds (until the message
I N I T I A L I Z E
appears). Then hold down the button for
three more seconds (until the message
RESET
appears) to return all SelecType
functions to the factory settings. See the
section on initializing SelecType for full
details.
CAUTION: This initializing procedure returns all
SelecType options to their factory settings, cancelling all
changes you have made. It should be used with care.
SET
Use the
SET
button to select and set
SelecType options.
Using the Printer 3-11