Setting the dip switches for the serial interface – Epson Action Laser User Manual

Page 52

Connecting the Printer to Your Computer

3. Use a screwdriver to fasten the screws of the connector, if

required.

4. Plug the other end of the cable into your computer. (Fasten the

screws of the connector to the interface, if required.)

This completes the connection of the serial interface cable. Now you

need to set the DIP switches for the type of serial interface you are

using.

Setting the DIP switches for the serial interface

The DIP switches are factory set for the RS-232C interface. If you are

using the RS-422A interface, you need to change the DIP switches

according to the table below.

2-14

Testing and Connecting Your Printer