Epson Action Laser - Manual (Page 170)

Printing Problems
Problem Solution
The printer does not
print or stops
printing.
The ON LINE
message appears but
nothing is printed.
The interface cable may not be plugged in
securely. Check both ends of the cable
between the printer and the computer. If
you are using a parallel interface, secure
the connector using the wire retaining
clips.
You may not be using the correct interface
cable. Make sure that your interface cable
meets the specifications for the printer
and computer.
You may not have selected the correct
interface settings with SelecType. Select
the appropriate interface (serial or
parallel). If you are using a serial
interface, also set the baud rate, protocol,
data bit, and related settings. See
Chapter 3 for information on using
SelecType. Also check your computer
manual for interface requirements.
You may not have set the DIP switches
correctly. DIP switches must be set for
either the RS-232C or the RS-422A serial
interface. (Not required for a parallel
interface.) See Chapter 2 for details.
7-14 Troubleshooting