Epson Action Laser - Manual (Page 136)

Routine Printer Cleaning
Note: Locate some isopropyl alcohol to use for cleaning purposes
before proceeding.
1. Make sure the printer is turned off; then disconnect the power
cord from the wall outlet. Also be sure that the printer cover is
open and that the basket is removed from the printer.
CAUTION: This procedure exposes the green drum unit,
which is in the basket. Because the drum is light-sensitive,
it should not be exposed to room light for any longer
than necessary (a few minutes at most). Thus, it is
recommended that you cover the drum unit with a soft
cloth or sheet of paper whenever the drum is exposed.
2. Locate a cotton swab.
3. With the printer cover open, locate the transfer charger wire and
the discharge wire, which are in indentations at the bottom of
the printer, beneath where the basket normally rests. These
wires are thin and difficult to see.
wire
6-20 Maintenance and Transportation