Epson Action Laser - Manual (Page 40)

Testing the Printer
The laser printer has three built-in print tests: the self test, font print
test, and status print test. These tests let you check the operation of
your printer and obtain information on printer status.
It is recommended that you run the self test before you begin using
your printer to make sure the printer is operating correctly. This test
is also useful for checking the print density setting on your printer.
The other two tests, the font print test and status print test, can be
run any time you need information on fonts or printer status.
Before running any of these tests, make sure you have removed all
protective materials from the printer and that you have installed all
components as described in Chapter 1.
Note: You do not need to connect the printer to your computer
before running these tests. (Connecting your printer to your
computer is described later in this chapter.)
Before performing these tests, it is necessary to turn on the power
and load paper as described below.
Turning on the power
1. Make sure the printer is plugged in.
2. Turn on the power by pressing the side of the power switch
marked with the vertical bar.
2-2 Testing and Connecting Your Printer