Hestan 48 Inch Freestanding Dual Fuel Range Use and Care Manual - Manual (Page 15)

© 2019 Hestan Commercial Corporation
13
EN
GETTING STARTED WITH YOUR APPLIANCE
(CONTINUED)
OVEN RACKS
BURN HAZARD - To help prevent burns, never remove or reposition the oven racks when the oven is
in operation, or is cooling.
For safety considerations, NEVER cover any slots, holes, or passages in the oven bottom or cover an
entire oven rack with materials such as aluminum foil. Doing so blocks air flow through the oven
and may cause carbon monoxide poisoning. Aluminum foil linings may also trap heat, causing a fire
hazard.
PLACING THE OVEN RACKS
The oven features ladder racks on the left and right side of the oven with 6 positions. Choose
the rack position(s) that result in the best baking, roasting, etc. for your recipe. Rack position #3
(counting from the bottom-up) is the most popular position (vertical center location).
The main oven features racks with full-extension, ball-bearing
slides which require minimal maintenance. The companion oven
(model KRD48) has traditional wire racks.
ALWAYS REMOVE THE LADDER RACKS, OVEN RACKS, AND
ALL OTHER ITEMS FROM THE OVEN DURING THE SELF-
CLEANING CYCLE.
1
2
3
1. Do not extend the slides - it is easier to install the rack when
NOT extended.
While raising the front of the rack slightly, place the rear
hook onto the desired ladder rack, then slide the small tab
under the ladder as you flatten out the rack.
2. Continue sliding the rack back into the oven.
3. When you reach the front-most hook, slightly lift the rack
again to hook over the ladder.
Move the rack a few times in and out to ensure it is locked
into the ladders and will not detach.