beautypg.com

Epson LT-286 User Manual

Page 79

background image

Turning Off the Hard Disk Before Starting the Computer

If you are not going to use the hard disk at all, turn off the switch

before turning on the computer. Insert a working copy of your

Startup/Operating 1 diskette in drive A so that MS-DOS is loaded

from that drive. When you turn on the computer, the screen
displays this error message:

1780 - Disk 0 failure

(Resume = "F1" key)

Do not be concerned by this message; just press

F1

to continue.

Then use the computer as if it had no hard disk drive. That is, you
perform all operations on the diskette in the diskette drive.

When you start the computer with the hard disk drive turned off,
you cannot access the hard disk even if you subsequently turn it on.

MS-DOS displays an error message if you issue any command
involving drive C. To make your hard disk accessible again, save

your data, exit the program you are running, then turn the
computer off. Wait at least five seconds, then turn the hard disk

switch on. Remove any diskette from drive A and turn the

computer back on.

Turning Off the Hard Disk After Starting the Computer

If you want to use the hard disk at any time during your working

session, start the computer with the hard disk switch turned on.
After you have loaded your application program into memory, you

may then be able to turn the hard disk drive off (if you do not need
to use it). When you want to save your work to a file on the hard

disk, you can then turn the hard disk switch back on again.

Note

Some application programs may not work with the hard disk

drive turned off unless they are started from a diskette instead of

from the hard disk. If you need to run a program of this kind and

you need to turn the hard disk off to conserve battery power, use

the diskette that came with the program and run it from drive A.

Using the Equity LT-286

4-19