Epson LT-286 - Manual (Page 41)

Mass Storage
The setup program assumes that your computer has an internal
1.44MB 3 1/2-inch floppy disk drive, an internal 20MB hard disk,
and that you are not using an external 5 1/4-inch diskette drive. If
this is true, you do not need to make any changes to the Mass
storage
portion of the setup program.
To change the mass storage information recorded by the setup
program or to confirm that the current settings are correct,
highlight
Mass storage
and press Enter. The following display
appears:
Exit Exit
Memory Memory
Display Display
Coprocessor Coprocessor
Mass storage Mass storage
Backlight period
Gray scale
I >
B(external):
2(20MB)
S AVE S ETTIN GS *******
If you are using an external 5 1/4-inch diskette drive, highlight
Then press Enter to select the type of
external diskette drive you have installed. As you continue to press
Enter, the display cycles through the available options: 360 KB,
1.2 MB, and None. Select the appropriate option for your system.
Your hard disk is most likely a Type 2,20MB disk. If it is not,
highlight Drive c and press
Enter. Then press Enter to select the
type of drive you have installed. As you continue to press Enter,
the display cycles through the available options: Type 3 (40MB),
Type 4
(40MB) , None, and Type 2 (20MB).
Select
the
appropriate option for your system.
Running the Setup Program 2-7