Connecting a printer, Connecting to the parallel interface – Epson LT-286 User Manual
Page 17
charge for at least five minutes before you start using the computer
the first time, and leave the AC adapter connected while you use
the computer.
Be sure to read “Using the Battery” in Chapter 4 for information on
using the computer with the battery. It explains how to charge the
battery fully; you should do this as soon as possible with your new
computer.
4
Connecting a Printer
The Equity LT-286 has both parallel and serial interfaces
(ports). You can easily connect a printer or plotter that has either
type of interface. Just follow the instructions below. Of course,
Epson offers a full range of printer products; consult your dealer for
more information.
Connecting to the Parallel Interface
The computer’s Centronics®-compatible parallel interface uses a
25-pin, D-shaped female connector. Most Epson printers have
parallel interfaces.
To connect a printer to the computer, you need an IBM-
compatible printer cable. If you’re not sure which one you need,
consult your Epson dealer. Once you have a printer cable, follow
these steps to connect your printer to the parallel interface on the
computer:
1. Place the printer next to your computer.
2. Before you connect the printer, make sure the power switches
on the computer and printer are off. (The power switch for your
computer is located on the back of the machine, on the left side
as you face the keyboard.)
1-4
Setting Up Your