Epson LT-286 - Manual (Page 38)

To change the main memory setting, highlight
Main.
Then press
Enter one or more times until the correct value appears.
To change the expansion memory setting, highlight
Expansion.
Then press the + key (either the gray + on the right side of the
keyboard or the white + next to the backspace key) until the
correct value appears.
For example, if you have installed a 2MB memory expansion
module, press the + key until 2048KB appears. If you have installed
two 2MB expansion modules, press the + key until 4096KB
appears.
When you have finished making changes to the memory settings,
highlight
SAVE
SETTINGS
and press Enter.
Display
The setup program assumes that you are using either the built-in
LCD screen in its normal 80-column mode or a color monitor
(attached to the CRT connector) in 80-column mode. If this
information is correct, you do not need to make any changes to the
Display
portion of the setup program.
To change the display information recorded by the setup program
or to confirm that the current settings are correct, highlight
Display
and press Enter. The following screen appears:
Exit
Memory
Display
Coprocessor
Mass storage
Backlight period
Gray scale
2-4 Running the Setup Program