2 ir cut control illuminators – Vivotek MD9584-HF3 5MP Outdoor Network Mobile Dome Camera with Night Vision, Heater & 3.6mm Lens User Manual

Page 229

VIVOTEK

User's Manual - 229

Group:

ircutcontrol_c<0~(n-1)>

for n channel products

(capability_daynight_c<0~(n-1)>_support >

n denotes the value of "capability_nvideoin"

NAME

VALUE

SECURIT
Y
(get/set)

DESCRIPTION

mode

auto,
day,
night,
di,
schedule…etc
* Available values
are listed in
"capability_daynig
ht_c<0~(n-1)>_mo
de"

dependent>

6/6

Set IR cut control mode
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.

sir

6/6

Enable/disable Smart IR
* Only available when
"capability_daynight_c<0~"capability_
nvideoin"-1>_smartir" is 1
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.

daymodebegintime

00:00~23:59

6/6

Day mode begin time
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.

daymodeendtime

00:00~23:59

6/6

Day mod end time
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.

bwmode

6/6

Switch to B/W in night mode if
enabled.
* Only available when
"capability_daynight_c<0~(n-1)>_
blackwhitemode" is 1.

* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.

sensitivity

low,normal,high,1
~100

6/6

Sensitivity of day/night control.

There are two value format:

"low,normal,high"

: if

capability_daynight_c<0~(n-1)>_ircuts
ensitivity_type=options

"1~100"

: if

capability_daynight_c<0~(n-1)>_ircuts
ensitivity_type=normalize

* Only available when
"capability_daynight_c<0~(n-1)>
_ircutsensitivity_type" is not "-".
* We support this parameter when
the version number (httpversion) is
equal or greater than 0312a.

7.10.2

IR cut control Illuminators

Group:

ircutcontrol_illuminators

(capability_daynight_c<0~(n-1)>_support > 0)

n denotes the value of "capability_nvideoin"
k is determined by the below criterion:

The following applies for capability_extension_do_num >= 0

* if extension_connected=1, k=capability_ndo
* if extension_connected=0, k=capability_ndo+ capability_extension_do_num

Otherwise,

* k=capability_ndo

NAME

VALUE

SECURIT
Y
(get/set)

DESCRIPTION

builtin_irled_enabled

6/6

Enable/disable built-in IR led
* Only available when
"capability_daynight_illuminators_buil