Vivotek MD9584-HF3 5MP Outdoor Network Mobile Dome Camera with Night Vision, Heater & 3.6mm Lens - Manual (Page 187)

VIVOTEK
User's Manual - 187
© 2022 VIVOTEK INC. All Right Reserved
56
7.7 IP Filter
Group: ipfilter
NAME VALUE SECURITY
(get/set) DESCRIPTION
enable 6/6 Enable access list filtering.
admin_enable 6/6 Enable administrator IP address.
admin_ip string[43] 6/6 Administrator IP address.
maxconnection 1~
"capability_protoc
ol_maxconnection" 6/6 Maximum number of (s).
type 0, 1 6/6 Ipfilter policy :
0 => allow
1 => deny
ipv4list_i<0~9> Single address: address>
Network address:
network mask>
Range
address:address - end ip
address> 6/6 IPv4 address list.
ipv6list_i<0~9> string[43] 6/6 IPv6 address list.
7.8 Video Input
Group: videoin
* We do not support this parameter when "capability_nvideoin > 1".
NAME VALUE SECURITY
(get/set) DESCRIPTION
cmosfreq
50, 60 4/4 CMOS frequency.
* Only available when
capability_videoin_type is 2.
* We do not support this parameter
when "capability_nvideoin > 1".
* This parameter will not be used
© 2022 VIVOTEK INC. All Right Reserved
57
NAME VALUE SECURITY
(get/set) DESCRIPTION
after the version number (httpversion)
is equal or greater than 0400a.
whitebalance auto,
panorama,
manual,
rbgain,
widerange,
outdoor,
indoor,
sodiumauto,
etc
(Available values
are listed in
"capability_image_
c<0~(n-1)>_wbmo
de") 4/4 Modes of white balance.
"auto" : Auto white balance
"panorama" : indicates that camera
would try to balance the white
balance effect of every sensor.
"rbgain" : Use rgain and bgain to set
white balance manually.
"manual" : 2 cases:
a. if "rbgain" is not supported, this
means keep current white balance
status.
b. if "rbgain" is supported, "rgain"
and "bgain" are updated to the
current values which is got from
white balance module. Then, act as
rbgain mode
"widerange" : Auto Tracing White
balance (2000K to 10000K).
"outdoor" : auto white balance mode
specifically for outdoor.
"indoor" : auto white balance mode
specifically for indoor.
"sodiumauto" : sodium vapor lamps.
* Only available when
"capability_image_c<0~(n-1)>_wbmo
de" !="-"
* We do not support this parameter
when "capability_nvideoin > 1".
* This parameter will not be used
after the version number (httpversion)
is equal or greater than 0400a.
exposurelevel 0~12 4/4 Exposure level
"0,12": This range takes the concept
from DC's exposure tuning options.