Sony E 16mm f/2.8 Lens User Manual
Page 57
57
Setup procedure
Follow the steps below to perform HDR-SDR conversion. This procedure assumes that “VPID/HDMI Auto”
and “SR Live Auto” are “Off.”
1
Assign “Conversion” to the function button.
2
Under “EOTF” and “Color Space” in "Ch. Setting,” check the OETF and color space of the pre-
conversion HDR signal displayed on the screen.
For Side by Side, the HDR signal input to Screen A will be converted.
3
In “Ch. Setting,” select the conversion preset data for the conversion settings.
4
Set each item of the conversion preset data.
Notes
“Preset1“ to ”Preset10“ of ”Conv. Preset" are preassigned with data. See page 59.
When “SR Live Auto” is set to “On” in “Ch. Setting,” the relevant items in the HDR SDR Relation
Table will be automatically set up if SR Live Metadata (HDR SDR Relation Table) is superimposed
on the SDI input signal. For items where SR Live Metadata is not superimposed or is invalid, the
setting value of the corresponding items in the conversion preset data will be applied. When “SR
HDR signal setting before conversion
(Conversion Off)
“Ch. Setting”
“EOTF”: Sets the OETF for HDR signals before
conversion.
“Color Space”: Sets the color space for HDR
signals before conversion.
When “VPID/HDMI Auto” or “SR Live Auto” is
“On,”
and
will be automatically set
based on the input signal information. If User
LUT is applied while
and
differ in input
signals and LUT output, turn Off the Auto
setting and set
and
to match the LUT
output setting in “Ch. Setting” as shown
above.
Performs HDR-SDR conversion on signals
displayed on the screen.
When performing HDR-SDR conversion on a
User LUT-applied signal, set “EOTF” (
) and
“Color Space” (
) according to the LUT
output specifications.
SDR signal setting after conversion (Conversion
On)
“Conv. Preset
”
“Out. OETF”: OETF setting for SDR signal
after conversion (SDR fixed)
“Out. Color Space”: Color space setting for
converted SDR signals
When Conversion is set to On, the setting
values in
and
will be internally processed
and automatically changed to match the
setting values of
and
.
Example:
Pre-conversion settings
“EOTF”: “ITU-R BT.2100(HLG)”
“Color Space”: “ITU-R BT.2020”
“Out. OETF”: “SDR” (2.4)
“Out. Color Space”: “ITU-R BT.709”
Post-conversion settings
“EOTF”: “2.4”
“Color Space”: “ITU-R BT.709”