beautypg.com

Lut type settings (type i / type ii / type iii) – Sony E 16mm f/2.8 Lens User Manual

Page 54

background image

54

When “Auto” is set to “On” and “EOTF” in “Ch. Setting” is set to “S-Log3(Live HDR)” or “S-Log3,“ LUT
input and output are identified as S-Log3 signals, and

Input is set to “S-Log Range.” Both

RGB/YCC Range and

Output are set to internal fixed values regardless of the settings.

5

Set “EOTF” and “Color Space” values in “Ch. Setting” according to the OETF and color space (gamut)
specifications for LUT output.

The signal to which the LUT data has been applied is displayed on the screen. With the optional
“PVML-HSX1” license (sold separately), LUT-applied signals can be output as SDI signals from the
ENHANCED MONITOR OUT connector.

LUT type settings (Type I / Type II / Type III)

The setting values for each LUT type are shown below. The LUT types, Type I/Type II/Type III, are
referenced from “BBC_HDRTV_HLG_LUT_Implementation_Guide.pdf” published by BBC Research &
Development.
The following setting procedure assumes that “VPID/HDMI Auto” and “SR Live Auto” are “Off.” Also, for
the settings

“Input” and

“Output” below, set “Auto” of “User LUT Range” to “Off”.

Type I

-For Limited Range input signals

Equivalent to supported LUT type No. 1. Set up as follows.

“RGB/YCC Range”: “Limited”

“Transfer Matrix”: Set the YCbCr to RGB transfer matrix for YCbCr input

“Input”: “Limited to Full”

“Output”: “Full to Limited”

“EOTF”: Set this parameter according to the OETF specifications for LUT output

“Color Space”: Set this parameter according to the color space (color gamut) specifications for LUT

output.

-For Full Range input signals

Equivalent to supported LUT type No. 8. Set up as follows.

“RGB/YCC Range”: “Full”

“Transfer Matrix”: Set the YCbCr to RGB transfer matrix for YCbCr input

“Input”: “No Scaling”

“Output”: “No Scaling(Full)”

“EOTF”: Set this parameter according to the OETF specifications for LUT output

“Color Space”: Set this parameter according to the color space (color gamut) specifications for LUT

output.

-For S-Log3 (Full Range) input signals

Equivalent to supported LUT type No. 12. Set up as follows.

“RGB/YCC Range”: Internal fixed value

“Transfer Matrix”: When inputting YCbCr, set the matrix for YCbCr to RGB conversion.

“Input”: “S-Log Range”

“Output”: Internal fixed value

“EOTF”: “S-Log3(Live HDR)” or “S-Log3“

“Color Space”: Set this parameter according to the color space (color gamut) specifications for LUT

output.

Input signal (Video Range)

Input Range settings

Output Range settings

LUT type

Limited Range

Limited to Full

Full to Limited

No.1

Full Range

No Scaling

No Scaling(Full)

No.8

S-Log3 signal

S-Log Range

Internal fixed value

No.12