Sony E 16mm f/2.8 Lens - Manual (Page 45)

45
License
Password
Confirm Performs an update.
Notes
 Do not turn off this unit while the
firmware is updating. If the unit is
turned off during an update, run
the update again.
 During the update, the LEDs on the
function buttons will blink in
sequence from F5 to F11 as the
update progresses. When the
update is complete, all the function
buttons light up. When updating
both "Software" and "Hardware,"
the updates will be performed in
the order of "Software" and
"Hardware," and all the function
buttons light up at the end of each
update. Be careful not to turn off
the unit even after the "Software"
update is finished. Updating both
takes about an hour. When all the
function buttons are lit for more
than 5 minutes, the update is
complete.
 Restart the unit by turning off and
on the power after the completion
of the update.
Submenu Setting
Unique Device ID Displays the Unique Device ID.
Load From USB Checks the destination where the USB
memory containing the optional
license is connected to.
License List If there is a valid license, the license
will be displayed.
Activation Select to run or cancel the activation of
the license.
 Cancel: Cancels the activation of
the license.
 Confirm: Activates the selected
license and restarts the unit.
Activated Licenses Displays the name of the license that
has been activated.
Submenu Setting
Submenu Setting
All Data Save Select whether a password will be
needed to perform an All Data Save.
Change Password Changes the password.
Note
The default password is “0000.”
Change the default before using “All
Data Save.”