Sony E 16mm f/2.8 Lens - Manual (Page 55)

55
Note
For Type I mentioned above, the Input/Output setting of “User LUT Range” is the same as the setting
when “Auto” of “User LUT Range” is “On.”
Type II
-For Full Range input signals
Equivalent to supported LUT type No. 10. Set up as follows.
 “RGB/YCC Range”: “Full”
 “Transfer Matrix”: Set the YCbCr to RGB transfer matrix for YCbCr input
 “Input”: “No Scaling”

“Output”: “No Scaling(Full)”

“EOTF”: Set this parameter according to the OETF specifications for LUT output

“Color Space”: Set this parameter according to the color space (color gamut) specifications for LUT
output.
-For S-Log3 (Full Range) input signals
Equivalent to supported LUT type No. 14. Set up as follows.

“RGB/YCC Range”: Internal fixed value

“Transfer Matrix”: Set the YCbCr to RGB transfer matrix for YCbCr input

“Input”: “S-Log Range”

“Output”: “No Scaling(Full)”

“EOTF”: Set this parameter according to the OETF specifications for LUT output

“Color Space”: Set this parameter according to the color space (color gamut) specifications for LUT
output.
Type III
Equivalent to supported LUT type No. 5. Set up as follows.

“RGB/YCC Range”: “Limited”

“Transfer Matrix”: Set the YCbCr to RGB transfer matrix for YCbCr input

“Input”: “No Scaling”

“Output”: “No Scaling(Full)”

“EOTF”: Set this parameter according to the OETF specifications for LUT output

“Color Space”: Set this parameter according to the color space (color gamut) specifications for LUT
output.